Need help running homeassistantOS as a VM. VM doesnt receive ipv4 address.
I have a local network where all the devices receive their ip from the router. IP range is 192.168.0.XXX.
On one of those machines i want to run "home assistant operating system" inside a VM using libvirt(using cockpit webgui).
I was able to install the VM, but when I run it, it never receives a IP address.
Setting one manual works, but then the VM doesn't show up in my local network.
On the host machine I created a bridge (virbr0) and I made the nic(enp8s0) from the host member. I also made VM member of virbr0
Any ideas what i'm doing wrong?
Note that the VM also needs to become member of the local network (ip range 192.168.0.XXX) and needs to see all other members of the local network.
Forget HA (for a while) and focus on the IP address problem. Start from scratch with a new VM, and/or inspect one of your VM's where the networking works. Find the difference.
Not an expert, just something I did and learned from; does the hardware you're running on have more than one ethernet port (enp#...)? Is it possible you've selected the wrong one?
Also I notice my VMs in proxmox have the bridge nomenclature of vmbr0 (not virb0). Perhaps something there?
Just throwing ideas out there, I'm pretty new at this.
OP, are all of the working-as-expected VMs also members of the virbr0 network?
I'm thinking that this is a firewall issue on your VM host. If you DO NOT have any other working VMs then could you try disabling the firewall on the VM host and see if the VM can receive DHCP traffic.