Skip Navigation

Is this one-piece battery-to-PCB "clip" standard (for easy replacement) or a custom piece? +PCB pad ?

Hello,

No formal training, but do like to repair devices at home (and keep vintage electronics and computers going).

Yet another alkaline battery has leaked prodigiously into a device (after only a few months). A wall-mounted thermostat.

Is the sort of clip pictured, which contacts an AA battery negative terminal at one end, and seemed to just clamp onto a conductive trace at the edge of PCB at the other, an easy-to-find standard form (for replacement) or a custom piece?

It is quite corroded and even peeling, and suspect replacing the clip would be better than devising a work-around.

Visually searching through product photos on supplier websites (like Digi--- and Mous-- here in the US) has not been effective.

Thanks for any comment.

7
7 comments
7 comments