Bigtreetech's btt pi is quite good for printer use - and general use tbh, but it is geared towards printers
I haven't had driver related issues with nvidia for a long time, last was some kde wayland stuff fixed a while ago, before that using x no issues for a long time
You need quite the opposite, more cooling on those overhangs. As you are in the chamber, the heated air wont cause warping like outside an enclosure, so crank those speeds on overhangs. I generally run 80-100% on bridges anf steep overhangs. I do also slow down print speed on overhangs significantly to allow more cooling aswell
May i see both of your works?? Id love to give em a read!
This would make so much more sense tbh, federating communities would also help bring the people who don't quite 'get' the fediverse yet into coming onboard instead of being lost.
it sounds like you need to invert the runout sensor detection, as it is triggering immediately.