First catastrophic nozzle clog!
First catastrophic nozzle clog!
Here's the carnage! Was running a long print and saw this when I went to check on it. Was running the stock Ender 3 hotend with a Capricorn tube fix for nearly 5 years. Served me well. I haven't yet been able to remove the white PLA. To see the full damage but, I'm pretty sure that the threads are gone.
Guess it's time to upgrade the hotend.
Honestly, if you just throw the whole hot end assembly (all electric components detached) in the oven at a low temp you'll probably be able to rip the whole blob off in one chunk and keep using it. Unless any cabling got damaged (entirely possible) I doubt anything is actually broken.
And at that point it’s probably time to get a new thermistor and cartridge anyway
Eh, not necessarily. Like I said before, the cables are really the only things you need to worry about in that area. When you consider how each of the components works, it makes it seem less damaging.
The heat cartridge is just two cables touching together inside a porcelain and metal housing that gets hot.
The thermistor is just two cables slightly air gapped inside another porcelain and metal housing to provide varying resistance depending on temperature.
Neither of these components will care if a huge blob of plastic temporarily adheres itself to the housing, so long as the cables remain intact.
My worry is stripped threads and, in even if not, I think it's probably about time to let the poor thing retire (until I repurpose it into a filament extruder). It's served me far better than I expected.
I would suggest setting your hot end to 80-90 degrees. At that temp, PLA becomes rubbery and pliable without being a melty burned out mess. You can then clip and remove the blob with care and proceed with breaking it down.
For other types of filament, you want to be just above the glass transition temperature and below the melting point. (usually it's a bit above your heated bed temperature.)
I'm not sure what you mean by stripped threads. Metal is stronger than plastic, there's nothing the PLA blob can do to cause physical damage to your hot end besides damaging cables. And I don't know what threads would be exposed to even be damaged.
I mean if you're wanting to buy a new hotend by all means get one, but don't do so thinking you have to because of this. I almost wanna guarantee everything still works as long as your cables are intact.
I'd call that a leak rather than a clog. :)