Prints have a ridge
Prints have a ridge
Any ideas as to what I'm doing wrong?
This sphere has a ridge on it, and I've had miniatures come out with the base to be slightly offset giving a bit of a ridge.
I'm using a Halot One, lychee Slicer, and Anycubic Water Wash resin.
1 crossposts
You're viewing a single thread.
All Comments
28 comments
That's just the foreskin.
Seriously though, if that happens on multiple prints, maybe there's something going on with the Z screw?
33 0 ReplyI've paused all the prints I've done (I've only had the printer for about a month), I'm hoping that's the issue. If not I'll definitely look into the z axis screw.
4 0 ReplyI'm not a resin expert, but that sounds pretty plausible. Good luck!
2 0 Reply
28 comments
Scroll to top