You're viewing a single thread.
All Comments
13 comments
It's gonna melt any day now because you didn't use glass filled nylon!
10 1 ReplyHaha. I was a bit concerned about it, so I used ASA, and it seems to be holding up alright. Fingers crossed it continues to do so.
5 0 Replylol, honestly I'd never even heard about ASA until you mentioned it. Is it easier than ABS?
2 0 ReplyIt’s not too bad. It does lift unless enclosed, but it’s basically ABS that’s slightly easier to print and UV resistant.
4 0 ReplySounds like a pretty good choice for this application!
3 0 Reply
13 comments
Scroll to top