3D Printed Spiral Vases
3D Printed Spiral Vases
I received a free broken CR-10S Pro V2 from my cousin, I finally have it repaired well enough to make these nice spiral vases. Here is the full album (not sure how to post albums here yet):
You're viewing a single thread.
7 comments
What was broken about it?
A whole lot lol. Replaced and heavily modified the extruder, extruder motor, filament runout sensor, bowden tube, hot end cooling fan, and part cooling fan/blower. Also had to take apart the hot end / heat break and clean out leaked globs that had stuck everywhere. Also modified the electronics cooling/intake fan setup with a dc/dc converter and 12v fans to reduce noise.
7 comments