Why do crosscut saws have a belly?
Why do crosscut saws have a belly?
This old catalog has large crosscut saws (sold by the foot!). They all have a rounded "belly" on the business side and I'm wondering why.
My best guess, without just googling it, is that it widens the last strip of wood thus reducing snap offs.
You're viewing a single thread.
My guess (and that's all it is, I'm no expert on this) is that with a rounded blade only a couple teeth are in contact with the wood at any one time so there's less resistance/friction. it's a lot easier to pull, say, 3 teeth through a piece of wood at once than 10.
Crosscut saws tend to be pretty long and are for cutting through pretty sizeable trees/logs, and if the wood is big enough the entire height of your saw is probably going to be inside the cut so that's a lot of potential for all kind of friction and pinching, so I'd imagine every little bit helps. It's probably less of an issue with regular hand saws and smaller lumber.
Most friction will be from the sides of the blade rubbing against the kerf. I believe it's just about concentrating force onto those teeth (which are essentially knives on crosscut saws, alongside chip clearing teeth).