Do people actually tune their printer for each new roll of filament?
Do people actually tune their printer for each new roll of filament?
I see a lot of people claim they tune/calibrate their printer any time they use a new spool of filament. But does anyone actually do this? It feels like a waste of time when filament is so consistent, even between brands. I can understand doing it for specialty rolls, but for basic pla? Seems unnecessary
You're viewing a single thread.
55 comments
I didn't on my FlashForge CreatorPro unless I had an issue, but I do on my BambuLab X1C - but that's because it's a fully automated process using the built in lidar.
Automatic flow calibration is so nice. I don't use any of the other "smart" features, but it's worth the extra cost just for that.
55 comments