Upgraded my Voxelab Aquila today to a PEI bed
Upgraded my Voxelab Aquila today to a PEI bed
My Voxelab Aquila came with a standard glass printbed. So far I thought I had no issues. Recently I thought I will printing PETG a try. Result -> no chance to get that print from the bed without damaging one of both (of course I let I cool down first). But even before I had more and more adhesion problems. So after a few friends suggested I gave the magnetic PEI printbed a try and so far I have to say I am pretty happy with it. Prints stick good and come out great. Should have done that already a while ago. Oh and because I was already working on it I changed the bed leveling springs to rubber buffers. Seems a lot more sturdy now.
You're viewing a single thread.
What are the other mods you have installed on this printer?
Oh hmm… that are quite a few:
- Satsana Fan Shroud (made by myself for 2x 4010 Noctua Fans)
- new PowerSupply Cover for bigger Fan and better ventilation
- riser feet (because the PSU fan needs more room and so air can better flow underneath)
- Raspberry Pi running OctoPrint mounted in the free section in the printer
- cablesupport against accidental breaking of the micro USB cable connecting printer and raspberry
- arm for holding my webcam (also connected to Raspberry)
- cablechain (had to remove the original cableguard due to the fan modifications)
- the PEI printbed
- side spool holder (originally on top. Bad angle for the standard Extruder as filament gets bend and damaged)
- display tuck (plan on putting my printer into an enclosure and with this it gets a little thinner)
- Z-Axis Guide on top, so that it’s a bit more sturdy
- I also changed all fans to Noctua ones and got it running around 45db while printing. But to be fair it might be a bit louder since I added the fan guards to the fan shroud. I kept putting my fingers in there somehow…
I think that’s all.
Future modifications:
Today I ordered an full metal dual gear Extruder and direct drive mount. That comes with removing the spool holder from the side and attaching it on the top again to keep an optimized angle for filament flow. Also I will probably have to redesign my Satsana fan shroud in order to make the direct drive fit.
Thanks
You’re welcome! If you are interested in specific parts I could possibly post a link to it.
The fan shroud is particularly interesting, also, when I tried to set up octoprint to with my Aquila it had issues with producing balls of material all over the print - have you run into this issue at any point?
Here you are:
https://www.printables.com/de/model/462590-dual-4010-fan-satsana-for-voxelab-aquila
And your problem with octoprint… did you still use Voxelmaker for slicing? How did you transfer the files and how did you start printing (via printers display or octoprints webinterface)? Also what Settings/Temps did you use? Could also be bad filament or moisture. I think best would be you post a picture in this community and describe it as exactly as possible.